- You cannot add that amount of "EVF FLIP UP WITH 2.5X Z-FINDER WITH DIOPTER AND ANTI-FOG" to the cart because there is not enough stock (0 remaining).
20 – 35MM SLIDES & COIN COLLECTOR PAGE 10 MIL (25 PACK)
Dimensions: 97?16“W x 11″H
Tips:
- For writing on preservers use the recommended Permapaque Markers.
- Remember to use gloveswhen handling negatives
- To remove dust use Falcon Dust-Off compressed air or Static Wisk
- To safely clean negatives use archival PEC-12 with PEC PADS
$17.95
In stock
Weight | 25 lbs |
---|
Related Products
$1,432.33Add to cart
EKTACOLOR RA Bleach-Fix and Replenisher NR / Part B To make 208 gal
EKTACOLOR RA Bleach-Fix and Replenisher NR / Part B To make 208 gal
$1,432.33Add to cart
$1,119.19Add to cart
Model 800 Water Panel
Hot and cold water filtration, & two 20 micron filter cartridges, vacuum breaker, .5-5 GPM flowmeter, adjustable spring check valves, compact design.
$1,119.19Add to cart
MODEL RELEASE CARDS PACK OF 25 PRV LBL
Model release short form on handy 3″ x 5″ cards. Easy to carry on assignments. Just stick in your camera bag. Pack of 25.
$2,955.76Add to cart
HZEKTACOLOR RA Bleach-Fix and Replenisher NR / Bulk Pack All Parts make 20gal
Kodak Ektacolor RA Chemistry is used in the processing of color prints RA-4 process, developed in, tray, drum, or rotary tube developing.
Use this Bleach-Fix NR for continuous processors with high utilization, it features a low replenishment rate. (It is not recommended for use in roller transport processors.)
Be especially careful not to contaminate the developer with bleach-fix; even minute amounts of bleach-fix can severely contaminate the developer.
To prevent developer contamination, use a separate mixing container for the developer.
Chemicals are supplied as all-liquid concentrates for easy mixing and handling
HZ**–This item is a HazMat item any orders that include Hazmat Items will incur a $25.00 per box fee over and above the shipping stated.
$2,955.76Add to cart
$3,217.99Add to cart
COMMERCIAL 210M – 115V
The Seal 210M Dry Mount Press is a table-top, heat-activated dry mounting system. It utilizes uniform heat and pressure to mount, laminate and texturize prints on substrates up to 1″ thick. Comes with a direct temperature readout for precise control. Manufacturer’s warranty covers on-site service only.
Platen Size | 23 x 18.5″ / 58.4 x 47 cm |
Maximum Thickness | 1″ / 2.5 cm |
Temperature Range | 150 to 300°F / 65 to 149°C |
Dimensions | W: 27 x D: 23 x H: 11 to 20″ / W: 66 x D: 58.4 x H: 27.9 to 50.8 cm |
$3,217.99Add to cart